Jump to content

  1. 12v_dub

    12v_dub

  2. Mode Red

    Mode Red

  3. freddyjbbq

    freddyjbbq

  4. CharlieB_DE

    CharlieB_DE

  5. DCJG

    DCJG

  6. ckreef

    ckreef

  7. danielc

    danielc

  8. keeperovdeflame

    keeperovdeflame

  9. Dub

    Dub

  10. SirCooksALot

    SirCooksALot

  11. John Setzler

    John Setzler

  12. karacooks

    karacooks



  • Similar Content

    • By Smokingdadbbq
      Had a few people who follow my Instagram ask for more information on the table shown in some of my pictures. 
       
      This is the cedar table work station I built to house my large and minimax big green eggs 
       
      so far pretty happy with it 





    • By g5spark
      The kj cart that was talked about months ago appears to be available now
       
      https://www.instagram.com/p/Bjk2eqznTpB/?hl=en
       

       
      Here's the product link in cdn dollars
      https://dicksonbbq.com/products/modular-cart-for-classic-joe
       
    • By kamadø
      Hello!
       
      New to the forum, and wanted to share something I did with those that may be interested. First thing I noticed is that tables and carts for Kamado grills are not cheap. I did some hunting around online and found a stainless table I liked for a good price, Kamado Joe's KJ-SST, only to then learn it would not fit the Classic II because of the new air lift hinge. Well, I wasn't giving up yet, as I felt there had to be a way to make this work. I found measurements for the table and began brainstorming. My first thoughts were to cut slits in the rear of the table to allow the hinge frame to fit since it didn't need a ton of clearance to begin with, but decided even though I wouldn't of had to cut all the way through the rear of the table, it still would of been weak, and the table is open in the rear below the table top. Started looking at the hinge, and noticed there is a lot of excessive material in the black frame. After feeling good about my measurements, I decided to order the table. I took some final measurements once the table arrived, and determined where I would need to cut the hinge frame to keep the grill pretty much centered and 1 inch off the bottom for airflow. I took the plunge and cut out my measured sections of the hinge frame with a hacksaw, then filed sanded and repainted the edges. Overall went very well, and the pieces I removed from the frame had zero affect on the hinge performance or strength. I have included pictures of the results, and can regather measurements to those that may be interested in doing the same. I bought the table on Amazon for $399, which is a great deal compared to prices of other tables, and wanted to let others know this can be done. Best addition to my KJ Classic II so far. Happy grilling!



    • By bhop
      So I've acquired a freestanding Joe and plan on bulding a combo table for it and the Junior. 
       
      As mentioned in the subject, will terracotta feet be substantial enough for the 250 lb BJ? I'm not against using several around the circumference if needed. 
×
×
  • Create New...