Jump to content


  • Similar Content

    • By Daz
      New toy for Akorn pitmasters! I made a pellet grill conversion on my Akorn in June and now it's going into production. Basically I ripped out a pellet feeder from a small pellet grill and made an adapter at the bottom of the Akorn grill. I just got the patent pending status so I can post it now. Here is a write up on the project. I'll update when we got the production prototype made...probably within a month.
      https://bbqube.us/Turn-Your-Akorn-Kamado-into-a-Pellet-Grill-with-BBQube-Pellet-Conversion-Kit_b_15.html?draft=1
       
       




    • By Daz
      Hi all, I was in love with my Akorn rotisserie setup but bored with birds, I decided to put some SLC ribs on a rotisserie setup. Ribs came from Costco pre-dry rub. Had three chunks of Kiawe wood on top of a snake of charcoals. No drip pan but the fire is on the side. Grill was around 350-400 degrees most of time and only took two hours for the ribs to be done. The rotisserie eliminated the under/over cooked spots and from now on I'll always do ribs on a rotisserie!
      Check out the video I made and enjoy the weekend 
       
       
    • By Fudpucker
      As the title suggests, I am looking for help getting my Akorn to act the way I want it to for smoking purposes. 

      I have the smoking stone, use a water pan, and lower my dampers until it basically snuffs out my fire, but I cannot seem to keep my Akorn at 225. 

      Now, I will admit that I am new to smoking and that there is a lot to be learned, but I have read tons of guides and watched videos and replicated them to my best ability, but still cannot get it to work for me. 
       
      Currently, my process is this:
       
      Open dampers all the way Fill bottom of grill full of hardwood lump Light with cotton balls soaked in alcohol Toss in a couple chunks of hickory Place my smoking stone Place my water pan Close lid and let set until 150 Close dampers halfway until 180 Close dampers again halfway until 210 Close dampers halfway one last time to about .5 on top and bottom.  
      1 of 2 things happens here. Either the temp keeps building to nearly 300 or the fire dies. 
       
      I play with the dampers making very small .5 adjustments to try and finagle it, but I cannot seem to get it right. 
       
      When I do seem to get the temps in a semi stable range around 230-260 (after LOTS of adjustments), after about an hour I go to spritz my meat with some apple juice and the temps take off again (Obviously because I just fed it a lot of oxygen) and never seem to come back down. 
       
      I have read about this "volcano" method of lighting the coals, but I literally have not found any videos or pictures on how to set that up. 
       
      Basically, I have no idea what I am doing wrong and I could use someone being critical of my process to give me some advice and direction. 
       
      Thanks for any feedback!

       
       
    • By Daz
      Finally I got around to finish this idea I had for a long time, ever since I made the pizza ring. I picked up a set of Weber Rotisserie and lathed part of the shaft round to fit the Akorn. I cut two little "V" on the pizza ring and the drive motor sits perfectly on top fo the side table - lucked out on that one! The chickens were marinaded with Hawaiian Huli Huli Sauce for two days, with some Hawaiian Salt Seasoning, freshly ground pepper and they turned out amazing. I gotta thank my neighbor who worked at a construction site and got me a tuck load of dried out Kiawe wood. It burns really hot and long lasting. I'm starting to put a kit together and will report back on the progress.
       
       
    • By Daz
      I dug up my old files today and found this hitch rack I designed and built back in 2015. I couldn't find the installed pic but I was hauling my akorn around with it. 
      Never made it to production but if there is enough interests here I may make a few sets. I'll tell you there will be a lot of compliments at traffic stops haha.
      The floor jack will be replaced with a standalone hand truck that can be used as a floor stand when the grill is off the truck. 
       
       



×
×
  • Create New...