Thanks to @Kamadobjorn for the inspiration. The table is the “Applaro” Line. The hardware that you see in the last pictures all came from Hobby Lobby. The table comes with a thin, cheap pull bar and nothing else, not even knobs for the doors. The cooler pic is just for reference as that was what I was doing prior to getting the table. The last pic is sans hardware just the way it comes from IKEA.
I used Lenox 18TPI metal jigsaw blades with an adjustable speed jigsaw set to its lowest setting to cut the hole. I used this edge trim from Amazon: Trim
New to the forum, and wanted to share something I did with those that may be interested. First thing I noticed is that tables and carts for Kamado grills are not cheap. I did some hunting around online and found a stainless table I liked for a good price, Kamado Joe's KJ-SST, only to then learn it would not fit the Classic II because of the new air lift hinge. Well, I wasn't giving up yet, as I felt there had to be a way to make this work. I found measurements for the table and began brainstorming. My first thoughts were to cut slits in the rear of the table to allow the hinge frame to fit since it didn't need a ton of clearance to begin with, but decided even though I wouldn't of had to cut all the way through the rear of the table, it still would of been weak, and the table is open in the rear below the table top. Started looking at the hinge, and noticed there is a lot of excessive material in the black frame. After feeling good about my measurements, I decided to order the table. I took some final measurements once the table arrived, and determined where I would need to cut the hinge frame to keep the grill pretty much centered and 1 inch off the bottom for airflow. I took the plunge and cut out my measured sections of the hinge frame with a hacksaw, then filed sanded and repainted the edges. Overall went very well, and the pieces I removed from the frame had zero affect on the hinge performance or strength. I have included pictures of the results, and can regather measurements to those that may be interested in doing the same. I bought the table on Amazon for $399, which is a great deal compared to prices of other tables, and wanted to let others know this can be done. Best addition to my KJ Classic II so far. Happy grilling!
Finally finished my Primo XL table. It's built out of pine and has 2in concrete counter top for plenty of space. It rides on 6 casters w/brakes. It will be parked in my garage and never be left out in the elements (at least on purpose...) It has 4 slide out racks that will hold charcoal, utensils, and extras for the XL