Jump to content

Top vent loose


Recommended Posts

  • 2 months later...

I finally got my gasket material this week! I had given up on it


The question now is do I remove the old one and install this?


Seems like if I just add a layer to the existing it will then be too thick.


The new roll is quite long. I guess if I remove the old it will be trial and error to get a good fit of the new material?


Any insight would be appreciated. I know I can figure it out, not rocket science here but if someone else has done it please share your expertise



Link to comment
Share on other sites

Well I just peeled off the old gasket, compared it to the new. The new is longer but not a whole lot so I figured it was cut to the proper length


I put it on then the vent, it went on real tight, almost too tight. So I tapped it down after working and twisting it in place and I think it will work fine.


So my advice is to use it at the length they cut it to and work the vent down into place.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...