Jump to content

Dome Adjustment Question


Recommended Posts

First, I apologize if this is the wrong category for this question.

 

Backstory... I have the KJ Classic 1.  After 6 years or so, my base cracked.  KJ sent me a new base.  Apparently the specs have changed over time because the new base wouldn't sit down flush in the stand and also the new base was about 3/4" larger in diameter than the existing dome.  KJ sent me a new dome, stand and hinge set to fit the new base.  World Class customer support !! 

 

My problem is, after assembling everything the dome isn't sitting flush all the way around the base.  The area at the back where the hinge is located, the two halves have very little if any compression on the gaskets.  The bands are level to the base and dome relative to the molded notch in the ceramics.  In my mind, to correct this I'd need to loosen the band bolt on the dome and let the back "sit down" then re-tighten but from the looks of it, if I do this the band is going to be up on the ceramic.  

 

Anybody out there ever run into this and have any suggestions?  Thanks

Link to comment
Share on other sites

3 hours ago, Greg Phillips said:

any suggestions?

If you have a Ace Hardware near you drop by and check with them, ace has good customer service and I'm sure they will help with getting it straight.

 

Scott

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...