Jump to content

Recommended Posts

It is sitting right on the hinge in the back.  Basically it is just wedged in the hole by it's shape.


The diameter of the grill is 22 inches at grate level.  So by doing 21.75 inch hole it just wedges in there.  I don't foresee any problems with this since the pressure is pretty equal being a circle of wood pressing on a circle of metal.


The front latch does not work any more because the table is too close to it, but i could cut the wood out to make it function again, but i rarely use it unless i was moving the grill.

Hey- any updates on this? Have you had any board warping or anything out the ordinary from the heat? 

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...